Furnace Repair in Cherry Creek

Cherry Creek's newer townhomes and rebuilt single-family homes usually have condensing furnaces in closets, basements or attics, vented through PVC, often with two-stage or variable-speed blowers and communicating controls. The common failures are condensate traps and drains, blocked vent terminations, pressure switch faults and control board errors. In stacked townhomes, a furnace on an upper floor needs a working secondary drain pan or float switch so a backup doesn't reach the ceiling below.

In Cherry Creek's condominium buildings, heat may come from a gas furnace in a unit closet, an electric air handler with heat strips, or a fan coil supplied by a building system. Before scheduling, it helps to know which you have and who maintains it. We can repair equipment inside your unit; problems with central building equipment are the association's to arrange. Building access, parking and elevator reservations also affect timing, so tell us about them when you book.

We start with a carbon monoxide and combustion safety test, then read fault codes and test the igniter, flame sensor, inducer, pressure switch, limit switches, blower and capacitor. At Denver's elevation, manufacturers require gas input to drop about 4 percent per 1,000 feet once installed above 2,000 feet, roughly a 21 percent derate, so we confirm gas pressure and temperature rise too. You get a flat-rate price before work starts, the diagnostic is free with the repair, and there are no overtime charges for nights or weekends. We carry common Trane, Lennox, Carrier, Goodman, Bryant and Rheem parts.

Cherry Creek is a Denver neighborhood, so furnace replacements go through the City and County of Denver's Community Planning and Development department. Xcel Energy supplies gas and electricity. Xcel has offered rebates on 95 percent AFUE or higher furnaces that replace non-condensing units when a participating contractor installs them, and Denver has run its own heat pump rebate programs, so check what is currently available before choosing equipment.

Repair usually makes sense for a single part on a sound furnace. Replacement is worth discussing for a cracked heat exchanger, an older furnace with repeated failures, or a historic home where new equipment and duct changes together would finally even out the heat.