Furnace Repair in Edgewater

Original ductwork in mid-century houses was often small, with few returns. A newer furnace pushing through those ducts can run at high static pressure, overheat and trip its limit switch, or burn out a blower motor early. When the back bedroom is always cold, the cause is usually airflow, and we measure it before suggesting any new equipment.

Newer, larger homes in Edgewater usually have condensing furnaces vented with PVC, sometimes in an attic or a second-floor closet, and often with two-stage or variable-speed equipment and communicating controls. Their common problems are condensate traps and drains, blocked vent terminations, pressure switch faults and control board errors. Reading the control's stored fault history is the fastest way to the cause. Attic and upper-floor furnaces also need a working secondary drain pan or float switch, because a condensate backup there can stain ceilings below before anyone notices.

After the carbon monoxide and combustion safety check, we read fault codes and test the igniter, flame sensor, inducer, pressure switch, limit switches, blower and capacitor. We measure gas pressure and temperature rise; manufacturers require input to drop about 4 percent per 1,000 feet above 2,000 feet, roughly a 21 percent derate at about 5,368 feet, and an unadjusted furnace can overheat and make carbon monoxide. You get a flat-rate price before we start, the diagnostic is free with the repair, and there are no overtime fees. We carry common parts for Trane, Lennox, Carrier, Goodman, Bryant and Rheem.

Edgewater requires a permit for furnace, boiler and water heater installations and replacements, and for converting from electric to gas heat. Applications go through the city's Community Core system online, and Community Development can confirm a permit and its inspections. We handle the permit for any replacement we install.

Repair is usually the right call for a single failed part on a sound furnace. Replacement makes sense for a cracked heat exchanger, a furnace past about 20 years with repeated failures, or a house where a new furnace and some duct work would finally fix uneven heat.