Furnace Repair in Mead

Flame sensors build up a thin coating over time, and when the furnace can no longer prove flame, it lights, runs a few seconds and shuts off, repeating until it locks out. Hot-surface ignitors crack with age. Control boards can fail after power surges or when a failing inducer or blower draws too much current.

We read the fault code history, then test each component in sequence. That way, we replace the part that actually failed and check whether something else caused it. A board that failed because an inducer motor was drawing too much current will fail again if only the board is replaced, so we measure motor amperage before signing off.

The town grew from 456 people in 1990 to 2,017 in 2000. Furnaces from those first subdivisions, if still original, are now 25 to 35 years old. At that age, heat exchanger cracks, inducer bearing failure and blower motor wear become more likely, and replacement parts can be harder to find.

We run a combustion and carbon monoxide test on every furnace call, and on these older units we also inspect the heat exchanger. If it has failed, we'll show you and explain your options.

Mead's resource directory lists both Xcel Energy and Black Hills Energy for natural gas. If you smell gas or several gas appliances stop at once, call the gas utility that serves your home first. If only the furnace is affected, the problem is almost always inside the furnace, and we check inlet and manifold gas pressure during the diagnosis.

We carry the parts that fail most on Trane, Lennox, Carrier, Goodman, Bryant, Rheem and comparable furnaces. Before any work, you'll have a flat-rate quote in hand; there's no overtime surcharge, and approving the repair makes the diagnostic free.

A failed sensor, ignitor or drain component is a repair at any age. Replacement makes sense when an older furnace has a failed heat exchanger, poor combustion numbers or several major parts failing at once. We'll give you prices for both.

The Town of Mead Building Division requires a permit to add or replace a furnace, and the same applies to water heaters, including tankless models, and new gas lines to appliances. If your water heater is the same age as the furnace, it can make sense to plan both replacements together.